LPC1754

芯片信息

型號 封裝 在線定購
LPC1754FBD80(查看) LQFP80

引腳布局

(點擊圖片看大圖)
技術資料—— LPC1754 PDF技術資料
LPC1754 參數
LPC1754 存儲器
Flash (KB) 128
RAM (kB) 32
LPC1754 其他參數
fmax (MHz) 100
I/Opins 52
UART 4
I2C 3
I2S -
SPI 2
SSP 2
ADC 6
DAC 1
定時器 6
PWM 6
I/O 電壓 (V) 3.3
CPU 電壓 (V) 3.3
LPC1754 封裝與引腳
LQFP80

LPC1754 概述

The LPC1754 are ARM Cortex-M3 based microcontrollers for embedded applications featuring a high level of integration and low power consumption. The ARM Cortex-M3 is a next generation core that offers system enhancements such as enhanced debug features and a higher level of support block integration.

The LPC1754 operate at CPU frequencies of up to 100 MHz. The ARM Cortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture with separate local instruction and data buses as well as a third bus for peripherals. The ARM Cortex-M3 CPU also includes an internal prefetch unit that supports speculative branching

LPC1754 特性

  • ARM Cortex-M3 processor, running at frequencies of up to 100 MHz
  • ARM Cortex-M3 built-in Nested Vectored Interrupt Controller (NVIC)
  • Up to 128 kB on-chip flash programming memory
  • Up to 32 kB of SRAM
  • In-System Programming (ISP) and In-Application Programming (IAP)
  • Eight channel General Purpose DMA controller (GPDMA)
  • Multilayer AHB matrix interconnect provides a separate bus for each AHB master
  • Split APB bus allows high throughput with few stalls between the CPU and DMA
  • USB 2.0 full-speed device/Host/OTG controller with dedicated DMA controller
  • Four UARTs with fractional baud rate generation
  • CAN 2.0B controller with one channel
  • SPI controller with synchronous, serial, full duplex communication
  • Two SSP controllers with FIFO and multi-protocol capabilities
  • Two I2C-bus interfaces supporting fast mode with a data rate of 400 kbit/s
  • 52 General Purpose I/O (GPIO) pins with configurable pull-up/down resistors
  • 12-bit Analog-to-Digital Converter (ADC) with conversion rates up to 200 kHz
  • 10-bit Digital-to-Analog Converter (DAC)
  • Four general purpose timers/counters
  • One motor control PWM with support for three-phase motor control
  • Quadrature encoder interface that can monitor one external quadrature encoder
  • One standard PWM/timer block with external count input
  • Real-Time Clock (RTC)
  • WatchDog Timer (WDT)
  • ARM Cortex-M3 system tick timer, including an external clock input option
  • Standard JTAG test/debug interface
  • Integrated PMU (Power Management Unit)
  • Four reduced power modes
  • Single 3.3 V power supply (2.4 V to 3.6 V)
  • One external interrupt input configurable as edge/level sensitive



捕鱼大师官方网 江苏快3玩法技巧 云南快乐10分走势图50 vr赛游戏机 秒速时时彩总和计划 双色球选号软件哪个好 今晚开什么特马号查询 单机游戏消灭糖果 广东时时一注多少钱 双色球历史四连号开奖 福彩3d直选三注内部资料